Shenzhen ATA Technology Co., Ltd
Shenzhen ATA Technology Co., Ltd specializes in LED products !
Add to Cart
Safety Information
1. The SMD light ribbon itself and all its components may not be mechanically stressed. Assembly must not damage or destroy conducting paths on the circuit board.
2. Installation of LED light ribbon (with power supplies) needs to be comply with all applicable electrical and safety standards. Only qualified personnel should be allowed to perform installations. Correct electrical polarity needs to be observed. Wrong polarity may destroy the ribbon.
3. Parallel connection is highly recommended as safe electrical operation mode.
4. Serial connection is not recommended. Unbalanced voltage drop can cause hazardous overload and damage the ribbon.
5. Please ensure that the power supply is of adequate power to operate the total load.
6. When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical insulated points between ribbon and the mounting surface.
7. Please pay attention to standard ESD precautions when installing the ribbon.
| Absolute Maximum Rating at TA=25°C | |||||
| Parameter | Symbol | Absolute Maximum Rating | Unit | ||
| ATA-NF60 | |||||
| Forward Current | IF | 2000 | mA | ||
| Forward Voltage | VF | DC 12 | V | ||
| Electrostatic Discharge | ESD | 400 | V | ||
| Operating Temperature | Topr | -25~+60 | °C | ||
| StorageTemperature | Tstg | -40~+80 | °C | ||